TT-02 Chassiabdeckung Polycarbonate

The TT-02 Chassis PC Cover Set adds a shaped polycarbonate layer over compatible TT-02 and TT-02FT chassis cars, creating a cleaner running area around the main chassis tub while keeping the layout light and easy to handle at the bench or track. The clear formed cover follows the chassis line closely and uses a separate switch cover to keep the installation neat around the power switch area. At the front, inner fenders can be attached to extend coverage around the wheel section. The mounting method uses touch fastener tape, with 2 strips measuring 9 x 150 mm supplied in the set, so the cover can be fixed in place and removed again when access to the chassis is needed. Hardware is also included with 6 screws and 6 thin 3 mm lock nuts, plus a TT-02 caution sticker sheet for finishing details that match the chassis application. This accessory suits TT-02 and TT-02FT builds prepared for regular running where a covered chassis layout is preferred. On short 251 mm wheelbase chassis using angled rear uprights 54549 or 54733 and offset 0 wheels, the cover may contact the tyres, so that configuration should be checked before fitting.