1:6 Carbon Decal Plain F, decal sheet, carbon look

Carbon Decal Plain F adds a carbon weave finish to scale builds with a single 130 x 190 mm wet-slide sheet that can be trimmed for exact placement. The plain layout leaves the full surface open for custom shapes, making it useful for winglets, spoilers, body panels and other areas where exposed carbon detail defines the look. Application follows a clear sequence: cut the required section, dip the decal in tepid water for about 10 seconds, place it on a clean cloth, then slide it from the backing sheet onto the model. Positioning is adjusted while the decal stays wet, and a soft cloth is used to press out excess water and trapped air. When curved surfaces need closer conformity, Mark Fit and Mark Fit Strong are recommended in the product data as decal setting solutions to help the film settle over uneven contours. The sheet is intended for static models across 1:6, 1:12 and 1:24 scale use, giving builders one material that can serve large motorcycle fairings, smaller car aero parts and detail inserts alike. On the bench, that means one sheet can cover both broad panels and narrow accents while keeping the carbon pattern consistent across the build.