New
€215.00
(within the EU)
only 3 pieces left in stock, Delivery time 1-3 working days within Germany
This item can only be delivered to the following countries:
Germany, Austria, Portugal, Netherlands, Hungary
Article number: 300058728
Product: 1:10 RC Super Sabre (2023) 4WD
Tamiya welcomes the re-released and updated version (this time, the body
is pre-cut and pre-painted in sliver) of the Super Sabre, the original
of which was released as Item 58066 in 1987. The Boomerang is a brother
model with the Super Sabre, and they are different in body and damper stay shapes.
4WD assembly kit, Vintage Chassis,
ESC included, Type 540 Motor,
Pre-painted polycarbonate Body,user guide
WARNING!
Read carefully and fully understand the instructions before commencing
assembly. A supervising adult should also read the instructions if a child assembles the model.
When assembling this kit, tools including knives are used. Extra care should be taken to avoid personal injury.
Read and follow the instructions supplied with paints and/or cement, if used (not included in kit).
Keep out of reach of small children. Children must not be allowed to put
any parts in their mouths, or pull vinyl bags over their heads.
Warning! Not suitable for children under 14 years.
Product details
- This R/C model assembly kit is a re-released and updated version of
the Super Sabre, a beginner-friendly buggy released in 1987. Length: 390mm, width: 234mm, height: 135mm.
- The 0.7mm thick polycarbonate body from Item 58066 is fitted with the
separate wing part, and is precut and pre-painted in silver.
- Shaft-driven 4WD gives speed and stability off road, and through corners.
- Damper stay components are original of this product.
- 4-wheel independent double wishbone suspension employs CVA short
dampers II with a front stabilizer to help get the most out of the 4-wheel drive.
- ABS bathtub frame and other reinforced parts give superb durability and simplified maintenance.
- Gearboxes are sealed to keep out dirt, and contain differentials for smooth cornering.
- Please note that body requires application of stickers, cutting and painting of figure, and other work.
Willem
05.01.2024
Back after 36 years!
Built the original back in 1987, so glad to see it being re-released. Had a blast with the original, but time took its toll on the plastic parts. Currently building the re-release, but ran into an issue with the front suspension: the drive shafts bind when the front end is unloaded (i.e. fully droops). I super-glued some rubber bits to address the binding issue, but in doing so I inadvertently stripped one of the lower A-Arms. Since this holds the front suspension in place, it renders the vehicle inoperable until I can get replacement parts (which are not available yet apparently). I therefore ordered another complete kit in the meantime, but if someone can tell me where I can get replacement F-Parts (#19005867) and the B-Parts (#19005195), then that would be greatly appreciated! Since the older kits precede the chassis codes now in use at Tamiya, it is harder to find replacement parts for the older kits - re-release or not. Otherwise I have always loved - and continue to love - the Tamiya R/C kits, even if they are a little more fragile than other brands...
0
4,0