3x10mm Alum. Turnbuckle Shaft, chassis accessory

These 3 x 10 mm aluminium turnbuckle shafts bring precise anti-roll bar adjustment to compatible chassis setups while adding a clear blue finish to the hardware. The set contains 4 shafts and is intended as a chassis accessory for fine tuning left and right anti-roll bar settings without removing the adjuster. The compact 3 x 10 mm dimensions suit dedicated on-road racing platforms where small setup changes matter. As a replacement for 9804250, this set gives a direct route to refreshing existing hardware with the same stated function. Compatibility is listed for TRF415MSX, TRF415MS, TB Evo. IV MS and TB Evo. IV. TA05 fitment is also specified, with the condition that adjusters must be shortened. At the workbench, these shafts support quick setup changes between runs when anti-roll bar balance needs a finer response. In regular maintenance, the 4-piece pack also helps keep a matching set ready for rebuilds, repairs or chassis-specific spares within a race box.

 

Warning! Not suitable for children under 14 years.