Aluminum Reinforced Tape, model accessory, 50 mm

This aluminum reinforced tape is made for model applications where high heat builds up close to the body shell. In gas operated vehicles, an exhaust pipe can run near the polycarbonate body, and the adhesive aluminum surface forms a heat resistant shield in that exposed area. The roll measures about 50 mm in width and 2 m in length, which gives flexible coverage for trimming sections to the required size. The reinforced construction suits placement along body areas that sit near hot exhaust routing, while the metallic surface is designed to handle heat exposure where direct proximity could otherwise mark or damage the polycarbonate. Scope of delivery: 1x aluminum tape reinforced. Used on RC vehicle body shells and similar model setups, the tape supports focused protection exactly where heat management matters most. It fits practical workshop tasks such as lining a body section near the pipe outlet, covering a local hot spot, or adding a barrier on an inner panel before the next run.

 

Warning! Not suitable for children under 14 years.