Heat Shrink Tubing Set, wire insulation, 100 mm

This heat shrink tubing set brings a clean, practical finish to model wiring jobs by tightening around cables when heat is applied with a dryer or similar heat source. The tubing is intended to insulate wire runs such as motor and ESC cables, creating a close sleeve over exposed sections, joins or connection points where a tidy covering matters. The set contains 7 pieces in 3 diameters, giving a useful spread for different wiring tasks. There are 5 pieces in 5 mm diameter, plus 1 piece in 3 mm and 1 piece in 2 mm, and every section is cut to 100 mm length. That mix supports both broader cable coverage and narrower sleeves for smaller leads. The black finish keeps the look uniform across custom wiring layouts, repair work and replacement cable sections in model setups. In use, a section is placed over the wire before heating, then shrinks down to fit the cable more closely. This makes the set a handy bench supply for insulating soldered areas, refining cable routing and finishing electronic installations with a more orderly result on model and accessory work.

 

Warning! Not suitable for children under 14 years.