Stabilizer Rod Stopper (4), RC chassis hardware

The Stabilizer Rod Stopper (4) is a small but important tuning part for RC chassis stabilizer setups. Each collar is fitted onto the sway bar and tightened with a grub screw to hold its position on the rod, so the bar can pivot up and down as intended while lateral movement is kept under control during loaded cornering. The set includes 4 stabilizer collars and 4 grub screws. This layout supports left and right positioning on a stabilizer assembly and gives a clean mechanical stop on the rod itself. The stopper design works as part of the stabilizer system rather than replacing the bar, and it is used with matching sway bar sets on specified chassis. Compatible applications listed in the data include TA06, TA06 PRO, TA06 MS, TB-04, TB-04 PRO, FF-03, FF-03 PRO, TB-03, TB-03 VDS, TA05 ver.II, M-07 CONCEPT, M-08 CONCEPT, TRF502X and DB02, each with the corresponding referenced set. On a touring car sedan setup, this kind of lateral control helps the stabilizer work consistently through repeated laps and setup changes. It suits maintenance, replacement and fine tuning on compatible chassis builds where accurate bar location matters to suspension response.