DT-03 Carbon Damper Stay Front RC Chassis Part

The DT-03 Carbon Damper Stay Front is a chassis upgrade part for DT-03 cars that brings a stiffer front damper mounting point to the suspension layout. Its carbon plate construction and symmetrical multi-hole pattern give the front end a clean, technical setup for damper installation, with the curved upper edge and twin lower tabs shaped to match the chassis mounting area. This set is supplied as ITEM 54562 and is intended to replace the standard C5 part on the DT-03 platform. The included hardware consists of 2 ball connector nuts, 2 3x8 mm screws and 2 3x0.7 mm spacers, which match the mounting points shown for the stay itself. The drilled positions allow adjustment of damper attachment points, which helps builders alter front suspension geometry through the mounting location rather than through unrelated chassis changes. The part is documented for use in place of C5 and for compatibility with the DT-03 CVA Damper Set. On a buggy prepared for loose dirt, compacted track sections or repeated jump landings, the front stay gives the suspension area a more focused base for setup changes. It suits workshop tuning sessions where front damper position, linkage fit and chassis response are adjusted step by step on a DT-03 build.