DT-03 Full Turnbuckle Set, RC chassis upgrade

The DT-03 Full Turnbuckle Set adds adjustable linkage hardware to DT-03 chassis cars, replacing fixed upper arms and tie-rods with 6 stainless steel turnbuckle shafts. Threaded adjustment makes it possible to fine-tune link length for a more exact chassis set-up while the buggy sits on the bench between runs. The set includes 2 shafts in 3x32 mm, 2 in 3x38 mm and 2 in 3x65 mm, covering the different positions used around the chassis. Each shaft uses an adjustment section that can be turned with the included wrench, so changes can be made without removing every linkage point first. Stainless steel construction gives the shafts a clean, precise finish suited to repeated set-up work, and the supplied attachment parts support installation on compatible DT-03 models. This upgrade suits drivers who want to refine alignment after a rebuild, correct steering link length, or make measured suspension changes for different running conditions. On a maintenance table, at a club session, or between outdoor buggy runs, the set gives the DT-03 platform a more tunable linkage layout with parts sized for direct compatibility.