1:6 Carbon Decal Twill F, water-slide decal sheet

Carbon Decal Twill F adds a fine carbon weave finish to scale models where molded surfaces alone cannot capture the look of exposed composite parts. The water-slide sheet is designed for areas such as winglets, spoilers and body panels, bringing a sharper technical texture to car and motorcycle subjects. The sheet measures 130 x 190 mm and comes without pre-marked shapes, leaving each section free to be trimmed for the exact panel or contour being covered. The application method is straightforward: cut the required shape, dip the decal in tepid water for about 10 seconds, place it on a clean cloth, slide it from the backing sheet onto the model, then press it down gently to remove excess water and trapped air. When used with MARK FIT or MARK FIT STRONG decal setting solutions, the film can be formed more easily over curved surfaces. The fine twill pattern suits scales from 1:6 to 1:24. On a race bike fairing, a rear wing or a detailed body section, the sheet helps tie painted and molded parts together with a consistent carbon appearance. It also gives builders a practical way to finish custom-cut sections on static display models where surface pattern and scale fidelity matter.